ER-0128 2004-2010 Duramax CCV Reroute kit

-Package lncludes:

1*Reroute Fittings
2*Reroute Port Plugs
1*Resonator Plug
1*PVC Pipe
4*Flange Clamps

Step 1:

1. Remove the intake pipe.

2. Loosen all 6mm bolts on the valve cover and loosen the hose clamp located in the center,then remove the PCV crossover pipe. Keep the bolts in place and they will be used later.

Step 2:

The installation kit provides two steel billet accessories. The O-ring end will be installed in the valve cover. itis best to apply a little oil on the O-ring for easy installation.

Step 3:

Insert the black plug provided in the kit into the airintake and secure it with a zip tie.

Step 4:

The advisable method for routing the hoses is to position both of them in the wheelcompartment on the passenger side. By doing so, potential odor problems associated withplacing hoses on the driver’s side within the cab can be minimized. Measure accurately and cuta supply hose to a length of 5.5 feet.

Step 5:

1. Connect the longer hose to the steel billet joint on the driver side and connect it with theprovided hose clamp. As shown in the above figure, arrange the hose behind the air pipe.

2.Connect the shorter hose to the passenger side connector and connect it with theaccompanying hose clamp. Connect the two hoses together with zip ties and run them parallelas shown above.

Step 6:

1. Guide the hose through the outer side of the frame and extend it to the wheel cover area atthe rear of the upper control am. Ensure that the hose is arranged along the outer side of theframe to effectively avoid and clean the exhaust system.

2. Next, use two zip ties to securely fasten the two hoses to the torsion bar. Subsequently, trimthe hose to an appropriate length, ensuring that its end is located approximately 2 inches belowthe torsion bar. Finally, simply reinstall the intake pipe and muffler according to the instructionsin step 1, and then you can drive the vehicle. Please note that this product is specificallydesigned for use in off-road environments.